3 x 6 STEEL AWNING IN BLUE WITH SIDES

The awning frames are constructed from 2mm gauge, 29mm box section steel, finished with white powder coating. It comes fully assembled, it is very strong and erects in less than one minute.
The roof canopy is manufactured from 350g polyester P.U. coated to ensure it’s fully waterproof. The roof canopy is a fully tailored fit to the frame work.
They come complete with a carrier bag for the sides, and an outer bag with large pockets
The zip sides are made from the same 350g P.U. coated polyester to ensure complete rain proofing.
The sides have one door 2m wide which can be rolled up, they also have three clear windows with roll up blinds.
The sides fix to the frame work using Velcro and ties, each panel has zipped ends and when zipped together ensures a water tight and windproof seam on all corners as well as a professional look.
As all sections have zipped ends you can fix to suit your requirements or conditions of the day.

THE 3x6 AWNING IS NOW ONLY AVAILABLE IN NAVY BLUE

Instructions
Step 1
Remove shelter from bag

Step 2
With partner opposite you, take hold of the legs, lifting slightly from the ground.

Take a few steps backwards and extend arms, pulling the frame out.

Step 3
Once your arms are fully extended, take hold of frame in the middle again, and again lift slightly from the ground. Take a few steps back extending arms, pulling the frame further out.

Step 4
Go to the inside of the shelter and gently push together the 3 apexes while rising the frame off the ground, allowing it to fully extend. Clip the 4 corner joints and 2 centre joints into position over locking buttons.

Step 5
Extend legs out until buttons until the buttons pop out.
Part No : AWN600